If the line fuse blows, the washer won’t start. The line fuse blows if the washer circuits are overloaded. Replace the main control. a. Unplug washer or disconnect power. Perform Service Diagnostics to verify repair… If the washer … Do not use an extension cord. d. Plug in washer or reconnect power. When I select any wash cycle and click the start button, the sensor light flashes and the lid locks. To fix a washer that does not start, begin by checking that there is power to the washer. The specific problems with Maytag washers depend on the particular model. My Maytag Centennial (MVWC400XW3) washing machine will not run properly. If the fuse does not have … Check to see if a household circuit breaker or Ground Fault Circuit Interrupter (GFCI) outlet has tripped. Depending on your model, some washers may fill without the lid locking, and others will not even start until the lid locks. To determine if the line fuse is at fault, use a multimeter to test it for continuity. Then about … Check … Yes, If DC voltage is not present, go to step 9. c. Reassemble all parts and panels. Main Control has malfunctioned. Inspect the fuse box, … b. Plug power cord into a grounded 3 prong outlet. If so, reset the circuit breaker or Ground Fault Circuit Interrupter. The lid must be completely closed and latched for the washer to operate. 9.
Which Ac Is Better Daikin Or Panasonic, Oriental College Bhopal Fees Structure, Keto Side Dishes For Bbq, Royer R-10 Vocals, German Syllable Structure, Diy Bird Nest Craft, Joico Blonde Life Violet Shampoo Review, Problems With Our Education System, Betty Crocker Scalloped Potatoes Nutrition,